SerVision CVG-M Technical Information PDF herunterladen (Seite 95)

SerVision Embedded Video Gateway System Guide

Configuring Camera Settings 94

Field

Description

Go To Preset

All PTZ cameras connected to the Video Gateway that support presets are listed below

this heading. If you want one of these cameras to automatically aim at a preset location

when a motion detection event begins, beside the name of the camera, select the number

of the preset location.

Note: Preset locations are defined and assigned numbers using a client application such

as the MultiClient. For additional information, please refer to the relevant client application

guide.

Note: If no PTZ cameras are connected to the unit, this field does not appear.

11. Under On Motion Ended, select the actions that the Video Gateway should perform when a motion detection

event ends, as described above.

Configuring Video Lost

The Video Gateway monitors the camera connections. If the video signal from a camera is lost – i.e., the Video

Gateway is not receiving video from it, either because of a malfunction in the camera, or because the camera has

been disconnected from the unit or from its power source – the unit can respond in any or all of the following ways:

 Upload video of the event to an FTP server on the internet (see Automatically Uploading Video to an AVV

Server, page 64). If e-mail notification recipients are defined in the SMS and E-mail screen, an e-mail

message is sent to all the recipients when the Video Lost event begins and a second e-mail is sent when the

video is successfully uploaded and is available for downloading by users. Each e-mail notification includes a

link to the video file on the server and a picture of the event.

 Send event notifications to the SMS and/or e-mail recipients defined for the system (see SMS and E-mail

Notifications, page 58). If AVV is activated, e-mail notifications include a link to video of the event that

includes the seconds preceding the time when the video signal was lost (the pre-record; see Video Recording

Settings, page 96). Video-Restored e-mail notifications can optionally include a picture of the event.

 Turn an activator on or off.

 Move any PTZ camera connected to the Video Gateway that supports presets to a preset location.

These actions can be implemented when the event begins, when it ends, or both.



To configure video lost detection:

1. In the Camera configuration screen, under Video Lost, select the actions that the Video Gateway should

perform if video reception from the camera is interrupted, as described below.

Figure 104: Video Lost settings

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 202 203

Keine Kommentare

SerVision CVG-M Technical Information Seite 95