SerVision CVG-M Technical Information PDF herunterladen (Seite 118)

SerVision Embedded Video Gateway System Guide

Configuring Sensor and Activator Settings 117

 Camera 1: Full-screen display of live video from Camera 1

 Camera 2: Full-screen display of live video from Camera 2

 Camera 3: Full-screen display of live video from Camera 3 (HVG, MVG, UVG only)

 Camera 4: Full-screen display of live video from Camera 4(HVG, MVG, UVG only)

 Rotate: Full-screen display that cycles from one camera to the next. (The rotation delay is defined in the TV-

Out Settings screen; see Configuring a CCTV Monitor (TV-Out), page 28.)

 None: A digital clock is displayed, and no video is displayed.

Only one sensor connector can serve this purpose on each unit. The appropriate sensor connector for each model is:

 HVG: In6 (Sensor 6)

 MVG, UVG: In4 (Sensor 4)

 CVG, CVG-M: In1 (Sensor 1 – the only sensor connector)

NOTE: This feature can only be activated in the relevant Sensor configuration screen if it is first enabled in

the TV-Out screen (see Configuring a CCTV Monitor (TV-Out), page 28).

NOTE: On CVG and CVG-M models, this feature should not be used if the sensor is configured to trigger

outline-switching.



To configure a sensor as a CCTV display switch:

1. In the Main Menu, under Sensors, click the appropriate sensor (see above). The Sensor configuration screen

opens.

Figure 131: Sensor #4 configuration screen (MVG, UVG)

Note: Every time the CCTV display is switched, a sensor event is triggered. If notification settings are

activated, notifications will be triggered each time the display is changed.

2. Select the TV-Out Display Switch checkbox.

3. Click Update, and then save the settings. They will be implemented after the unit is restarted (see Saving

Configuration Changes, page 125).

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 202 203

Keine Kommentare

SerVision CVG-M Technical Information Seite 118