SerVision CVG-M Technical Information PDF herunterladen (Seite 88)

SerVision Embedded Video Gateway System Guide

Configuring Camera Settings 87

7. If you do not want audio to be incorporated with the video recorded from the camera, under Audio

Recording, clear the Enabled checkbox.

Note: The Audio Quality field is not currently in use. All audio recordings have medium quality.

Note: If recording is not activated, this checkbox cannot be cleared.

8. If you want to use the Video Gateway’s VMD features to detect and respond to motion in the camera’s field of

view, under Motion Detection (VMD), select Enabled. Then follow the instructions below (Video Motion

Detection (VMD), page 88).

Note: Be aware that on PTZ-controlled cameras each change of the camera position is interpreted by the VMD

system as an event.

9. Configure the unit's response to interruptions in the transmission of the video signal from the camera to the

unit as described below (Configuring Video Lost, page 94).

10. Configure the camera’s recorder as described below (Video Recording Settings, page 96).

11. Click Update. Changes to brightness, contrast, and saturation are implemented immediately. Save the settings

to implement them permanently. Save the settings and restart the unit to implement all other changes (see

Saving Configuration Changes, page 125).

Configuring PTZ

This section explains how to configure the pan-tilt-zoom (PTZ) controls of cameras that support these features.

Once the controls are configured, the camera can be aimed and zoomed remotely using any of the client

applications.

NOTE: For information about connecting the PTZ controller to the Video Gateway unit, please refer to the

unit’s installation guide.



To configure pan-tilt-zoom controls (PTZ) in cameras that support these features:

1. In the Camera configuration screen, under Camera Control (PTZ), select Enabled. The fields required to

configure the PTZ settings are added to the screen:

Figure 98: PTZ settings

2. Fill in the fields as follows:

 Field

 Description

Protocol

Select the communication protocol used by the camera for PTZ control.

Note: Consult the camera documentation or the camera vendor for this information.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 202 203

Keine Kommentare

SerVision CVG-M Technical Information Seite 88