SerVision CVG-M Technical Information PDF herunterladen (Seite 115)

SerVision Embedded Video Gateway System Guide

Configuring Sensor and Activator Settings 114

Field

Description

SMS

Select this option to have the Video Gateway send SMS notifications when the device

triggers an event. Messages are sent to the recipients specified in the SMS and E-mail

configuration screen in the format defined there (see

SMS and E-mail Notifications

page 58).

E-mail

Select the desired type of e-mail notification, as follows:

 None: Do not send e-mail notifications when an event is detected.

 Text only: When an event is detected, send e-mail notifications.

Include a text message in the e-mail, but do not attach any images to

the message.

 Text & image: When an event is detected, send e-mail notifications

that include both a text message and a picture of the first frame of

the event. If multiple cameras are attached to the device, a separate

e-mail is sent for each camera. If no cameras are attached to the

device, no e-mails are sent.

Note: E-mail messages are sent to the recipients specified in the SMS and E-mail

screen, in the format defined there (see

SMS and E-mail Notifications

, page 58).

Note: If AVV is selected, Text & image is automatically selected for this field. A single

e-mail containing both the standard notification text and the AVV notification is sent at

the beginning of each event. In addition, a text-only e-mail is sent when the file transfer

is completed.

Note: If AVV was once selected, and has since been cleared, Text & image remains

selected for this field until the selection is changed manually. If it is not changed, AVV is

not activated, but notifications with snapshots are sent at the beginning of each event.

Activator 1

Activator 2

(Sensors only)

Specify the action that each activator should perform when the sensor triggers an event,

as follows:

 Turn on: Set the activator line to “high.”

 Turn off: Set the activator line to “low.”

 None: Do not change the activator’s status.

Note: These settings are not available for activators.

Note: The Activator 2 field only appears for the HVG, MVG, and UVG.

Load Outline

(Sensor 1 only)

If Sensor 1 is a toggle switch that will be used to switch outlines, select Enabled, and

then follow the instructions under

Configuring Sensor 1 to Switch Outlines

, page 115.

Note: This option only appears if Outline Switching is set to Sensor in the General

Settings screen (see page 24) and if more than one outline is enabled in the unit's

configuration (see

Defining

Alternate Outlines, page 118).

TV-Out Display

Switch

(HVG: Sensor 6 only;

MVG and UVG:

Sensor 4 only;

CVG and CVG-M:

Sensor 1)

If a push-button switch connected to this sensor connector will be used to change the

display on a CCTV monitor connected to the unit, select this option. For additional

information, see

Configuring a Sensor to Control CCTV Display

, page 116.

Note: This option only appears if Display Switch Via Sensor is enabled in the TV-

Out screen (see

Configuring a CCTV Monitor (TV-Out)

, page 28)

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 202 203

Kommentare zu diesen Handbüchern

Keine Kommentare

SerVision CVG-M Technical Information Seite 115

Kommentare zu diesen Handbüchern