SerVision CVG-M Technical Information PDF herunterladen (Seite 87)

SerVision Embedded Video Gateway System Guide

Configuring Camera Settings 86

 Field

 Description

Brightness

Adjust the default brightness of the camera. Range: 1–100. These values are used when the

Video Gateway unit is started.

Note: You can also adjust the brightness in the client or in a CCTV monitor (with the

touch/mouse enabled) as you view the video stream (see page 83 ).

Contrast

Adjust the default contrast of the camera. Range: 1–100. These values are used when the

Video Gateway unit is started.

Note: You can also adjust the contrast in the client or in a CCTV monitor (with the

touch/mouse enabled) as you view the video stream (see page 83 ).

Saturation

Adjust the default saturation of the camera. Range: 1–100. Higher saturation produces more

vivid colors.

Note: Changes to brightness, contrast, and saturation are implemented immediately when Update is clicked.

4. If the camera has PTZ features, and you want to use them to control the camera remotely through a client

application, under Camera Control (PTZ), select Enabled. Then follow the instructions below (Configuring

PTZ, page 87).

5. Under Audio, select one of the following:



None: Do not link any audio to the video from this camera.



Channel 1: Link the audio from the microphone connected to Ain1 to the video from this camera.

 Channel 2: Link the audio from the microphone connected to Ain2 to the video from this camera (HVG,

MVG, UVG only).

Note: In HVG units that only support one microphone, you will either see Channel 1 or Channel 2 in the

dropdown list, depending on which one was activated. For additional information, see the description of the

Input Volume Ch 1 / Input Volume Ch 2 field (page 22).

If you selected None, skip to step 8.

If you selected either Channel 1 or Channel 2, audio from the selected microphone is available whenever you

view live video in a client application. In addition, the fields required to configure recording of audio with

recorded video from this camera are added to the screen, and a message appears indicating that audio

recording is enabled. This means that audio from the selected microphone is incorporated with all video

recorded from the camera.

Figure 96: Audio recording settings

Figure 97: Audio-recording-enabled message

6. In the audio-recording-enabled message, click OK.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 202 203

Keine Kommentare

SerVision CVG-M Technical Information Seite 87