SerVision CVG-M Technical Information PDF herunterladen (Seite 117)

SerVision Embedded Video Gateway System Guide

Configuring Sensor and Activator Settings 116

Figure 128: Sensor #1 configuration screen

Note: Every time the outline is switched, a sensor event is triggered. If notification settings are activated,

notifications will be triggered each time the display is changed.

2. Under When Sensor On, under Load Outline, select Enable. The Outline field is added to the screen.

Figure 129: Outline field

3. In the dropdown list, select the name of the outline you want to load when the toggle switch is turned on.

Figure 130: Selecting an outline

4. Under When Sensor Off, under Load Outline, select the name of the outline you want to load when the

switch is turned off, as described in steps 2–3.

5. Click Update, and then save the settings. They will be implemented after the unit is restarted (see Saving

Configuration Changes, page 125).

Configuring a Sensor to Control CCTV Display

You can use one of the sensor connectors on the Video Gateway unit to connect a push-button switch to the unit. If

a monitor is connected to the Video Gateway, the switch can then be used to change the display in the CCTV

monitor. With each press of the button, the display cycles to the next display type, in the following order:

 Split screen: The screen is divided into four parts, and live video from each camera is displayed in one of the

parts.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 202 203

Keine Kommentare

SerVision CVG-M Technical Information Seite 117