SerVision CVG-M Technical Information PDF herunterladen (Seite 116)

SerVision Embedded Video Gateway System Guide

Configuring Sensor and Activator Settings 115

Field

Description

Presets

(Sensors only)

All PTZ cameras connected to the Video Gateway that support presets are listed below

this heading. If you want one of these cameras to automatically aim at a preset location

when a sensor event begins, beside the name of the camera, select the number of the

preset location.

Note: Preset locations are defined and assigned numbers using a client application such

as the MultiClient. For additional information, please refer to the relevant client

application guide.

5. Under Notifications, under When Sensor Off or On Activator Deactivated, specify the actions that should

be performed when an event ends, as described above.

6. Click Update, and then save the settings. They will be implemented after the unit is restarted (see Saving

Configuration Changes, page 125).

Configuring Sensor 1 to Switch Outlines

A toggle switch can be connected to the In1 connector on the Video Gateway instead of a sensor. The switch can be

used to toggle between two outlines. For example, if an MVG is installed in a bus, when the bus is parked in the lot,

the “Parked” outline – which activates sensors, notifications, and event-triggered recording – can be loaded. When

the bus driver begins driving, he or she can flick the switch to load the “Driving” outline, in which sensors and most

notifications are deactivated, and recording is continuous.

NOTE: This feature can only be activated in the Sensor 1 configuration screen if it is first enabled in the

General System Settings screen (see General System Settings, page 19).

NOTE: In some cases, an alarm panel may be connected to In1 instead of a toggle switch. In this case, the

alarm can perform the same function as the toggle switch –when the alarm is turned on or off, it

automatically toggles the active outline as well. For additional information, please refer to the

installation guide or consult your vendor.



To configure Sensor 1 as an outline switch:

1. In the Main Menu, under Sensors, click Sensor 1. The Sensor #1 configuration screen opens.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 202 203

Keine Kommentare

SerVision CVG-M Technical Information Seite 116