SerVision CVG-M Installationsanleitung PDF herunterladen (Seite 6)

SerVision CVG Installation Guide

Additional Equipment 5

Additional Equipment

One or two video cameras should be connected to the CVG. You must acquire the cameras you require; they are not

included in the CVG package. For information about camera compatibility and about connecting the cameras to the

unit, see Connecting Cameras, page 9, or consult your vendor.

In addition to the cameras, you may wish to connect some or all of the optional equipment listed below to the CVG

unit. For additional information about these items and the cables required to connect them, please refer to the

installation instructions for each type of device.

NOTE: This equipment is not included in the CVG package.

 Dry-contact sensor, toggle (on-off) switch to change the active outline (see Connecting Sensors, page 11), or

push-button switch to change the display in a connected CCTV monitor (see Connecting a Switch, page 19)

Note: A dry-contact sensor or switch can be connected directly to the Sensor connector on the CVG unit. If

you use either an ADAM module or an IA relay board, as described below, you can connect an additional 16

dry-contact sensors via the unit’s RS232/485 connector.

Note: If you connect a touchscreen monitor to the CVG, you cannot also connect an ADAM module or an IA

relay board. In this case, you can only connect one dry-contact sensor to the unit.

 ADAM Data Acquisition Module and ADAM isolated RS232->RS422/RS485 converter, for connecting up to

16 dry-contact sensors (see Connecting Sensors, page 11)

 Intelligent Appliance IA-3126-2 relay board, for connecting up to 16 dry-contact sensors (see Connecting

Sensors and Activators Using an IA Relay Board, page 16) and 16 activators to the CVG unit

 Dry-contact activator (an alarm or other device that is turned on or off in response to the activation of a sensor;

see Connecting Activators, page 15)

Note: An activator can be connected directly to the CVG unit. If you use an IA relay board, as described

above, you can connect an additional 16 activators via the unit’s RS232/485 connector.

Note: If you connect a touchscreen monitor to the CVG, you cannot also connect an IA relay board. In this

case, you can only connect one activator to the unit.

 Microphone (see Connecting a Microphone, page 17)

 Speaker or headphones (the unit already contains a built-in speaker; for additional information, please refer to

the Embedded Video Gateway System Guide)

 CCTV monitor for closed-circuit video display (see Connecting a CCTV Monitor, page 18)

 Additional micro SD cards (see Appendix: Removing the Micro SD Card, page 23)

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Keine Kommentare

SerVision CVG-M Installationsanleitung Seite 6