SerVision CVG-M Installationsanleitung PDF herunterladen (Seite 20)

SerVision CVG Installation Guide

Connecting Devices to the CVG 19

 An appropriate connector (BNC or RCA) for the Video In connector of the monitor. (Consult the monitor

documentation or your vendor to find out which kind of connector is required for the particular monitor you

are using.)

 A BNC male connector to connect to the TV Out connector of the CVG. (A cable with an RCA connector can

be used by attaching a BNC-to-RCA adaptor to the connector. See figure 7, page 9.)

To connect the output of a touchscreen to the unit, you will need a cable with the following connectors:

 An appropriate connector to connect to the touch output connector on the monitor

 A female 9-pin RS232 connector to connect to the CVG’s RS232/485 connector.

An appropriate cable should be supplied with the monitor.



To connect a CCTV monitor:

1. Install the monitor in its desired location.

2. Connect the Video In connector of the monitor to the TV Out connector of the CVG, using a cable with an

appropriate connector (BNC or RCA) for the Video In connector of the monitor on one end, and a BNC male

connector on the other end.

Note: If you are using a standard television set as a monitor, use the television’s AV connector as the Video

Input connector.

3. If the monitor is touch-sensitive, connect the touch output to the RS232/485 connector as follows:

 If you are not connecting any RS485 PTZ controllers to the unit, connect the RS232 connector of the

touch output cable directly into the RS232/485 connector.

 If you are also connecting one or more RS485 PTZ controllers to the unit, connect the RS232 connector

of the touch output cable to the RS232 connector of the RS232/485 adapter supplied with the unit (see

figure 16 below). Connect the PTZ controllers to the adaptor as explained under Connecting a PTZ

Controller, page 9. Then plug the adaptor into the RS232/485 connector on the unit.

Figure 16: RS232/485 adapter

4. If the monitor is touch-sensitive, it is recommended that you calibrate it before you use it. For information

about how to calibrate the monitor, please refer to the monitor’s documentation.

Connecting a Switch

If you wish, you can connect a switch to the unit to change the display on the monitor. The switch must be

connected to the In1 connector. For additional information, see Connecting Sensors, page 11, and refer to the

Embedded Video Gateway System Guide.

Plug into RS232/485

connector on CVG-M

RS232 connector

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

SerVision CVG-M Installationsanleitung Seite 20